NACE Coating Inspector Level 1 認定 NACE-CIP1-001 試験問題:

1. When performing tests for oil and grease using an ultra-violet light, the NACE Inspector should be aware that:

A) Ultra-Violet light may contaminant the surface
B) Presence of weld spatter may produce a false positive
C) Synthetic oil or grease may not be identified
D) Chloride salt may produce a false positive

2. When applying Thermal Spray Coatings the specification is most likely to refence:

A) NACE SP 0178
B) SSPC PA 2
C) SSPC-CS 23.00/AWS C2.23/NACE No. 12
D) NACE SP 0188

3. You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

A) Advise the Contractor he cannot proceed
B) Advise the Contractor of your readings
C) Call your supervisor
D) Advise the Contractor he can proceed

4. Using SSPC Vis 1 as a guide when performing a visual inspection of a steel surface prior to surface preparation a NACE Inspector would assign which designations to the surface condition:

A) Surface Conditions E-G
B) Rust Grades 1-4
C) Rust Grades A-D
D) Surface Condition H

5. Excess moisture during holiday testing can cause erroneous indications by creating a path across the surface of the coating to pinholes previously detected, or directly to the signal return connection.
This is often referred to as:

A) juxtaposing.
B) transitioning.
C) monitoring
D) telegraphing.

質問と回答：