NACE Coating Inspector Level 1 認定 NACE-CIP1-001 試験問題:

1. You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

A) Advise the Contractor he cannot proceed
B) Advise the Contractor of your readings
C) Call your supervisor
D) Advise the Contractor he can proceed

2. You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

A) 45 Gauge readings resulting in 15 Spot Measurements
B) 105 Gauge Readings resulting in 35 Spot Measurements
C) 225 Gauge Readings resulting in 75 Spot Measurements
D) 75 Gauge Readings resulting in 25 Spot Measurements

3. Which one of these elements is not necessary for corrosion to occur:

A) Anode
B) Electrolyte
C) Reference Cell
D) Cathode

4. Which is a component that supplies most of the features and functions of the material?

A) binder
B) additive
C) pigment
D) solvent

5. Conventional spray is a good choice when:

A) High viscosity coatings are being applied
B) High production rates are required
C) High quality finishes are required
D) High transfer efficiency is required

質問と回答：