CompTIA Network + Certification 認定 N10-005 試験問題:

1. A technician has been tasked with planning and implementing a new wired-only network for a small office. A hardware list has been compiled, but the technician is unsure about the final necessary item. Which of the following will BEST complete the small wired network setup?
(1)
1000 foot CAT6 spool
(1)
crimper
(1)
16 port gigabit switch
(20)
RJ-45 connectors
(12)
RJ-45 wall jacks
(1)
____________

A) Multimeter
B) Compression tool
C) Network map
D) Punch down tool

2. A home user states during a basement remodel, one of the workers cut the network cable that goes from the modem to the WAP and nothing else has changed. According to the network troubleshooting methodology, which of the following is the NEXT step?

A) Identify the problem
B) Question the user
C) Establish a theory of probable cause
D) Establish a plan of action

3. A user reports intermittent network connectivity. Which of the following should a technician
configure on the managed switch to help troubleshoot this issue?

A) SMTP
B) SNTP
C) SNMP
D) SNAT

4. A technician has been dispatched to investigate connectivity problems of a recently renovated office. The technician has found that the cubicles were wired so that the network cables were run inside the conduit with the electrical cabling. Which of the following would MOST likely resolve the connectivity issue?

A) Test the wiring in the network jacks for faults using a cable verifier.
B) Re-run the network cabling so that they are 12 inches or more away from the electrical lines.
C) Power-cycle the computers and switches to re-establish the network connection.
D) Re-run the network cabling through the ceiling alongside the lights to prevent interference.

5. Which of the following wireless standards can operate on the same frequency but are not
compatible?

A) 802.11g / 802.11n
B) 802.11b / 802.11g
C) 802.11a / 802.11n
D) 802.11a / 802.11b

質問と回答：