最新のP6040-014問題集で試験を準備する

IBM P6040-014 試験概要:

IBM P6040-014 試験シラバストピック:

IBM SurePOS 500 Models 5x5 Technical Mastery 認定 P6040-014 試験問題：

1. What is one of the differences between IBM SurePOS Model 545 and Model 565?

A) Model 545 has only one USB port on the display; the 565 has three USB ports on the display.
B) Model 545does not have a PC Card slot; the 565 does have a PC Card slot.
C) Model 545 has 512MB of memory standard; the 565 has 1GB of memory standard.
D) Model 545 has a 20GB SATA II hard disk drive; the 565 has an 80GB SATA II hard disk drive.

2. Which three resources can be utilized for support assistance? (Choose three.)

A) IBMLink
B) IBM POS QuickReference Guide
C) IBM TechLine
D) IBM AnswerLine
E) IBM Retail Store Solutions Web site
F) IBM POS Support Web site

3. What is one of the differences between IBM SurePOS Model 545 and Model 565?

A) Model 565 has dedicated video memory.
B) Model 545 does not have audio capability.
C) Model 545 can beordered with an internal floppy drive.
D) Model 565 can be ordered with a 4GB embedded flash drive.

4. What is the easiest way to install the latest BIOS version?

A) attach the IBM SurePOS 5x5 to the Internet and download the BIOS version from the
IBM Retail Store Solutions Web site
B) load it from a USB attached floppy drive containing a diskette with the latest BIOS on it
C) run the Setup Utility and select Update BIOS
D) boot from the IBM Diagnostics for POS Systems and Peripherals and run the BIOS update utility

5. Which statement is true about the order of steps for installing a magnetic stripe reader (MSR)?

A) 1. with a screwdriver, pop out the MSR hole plugs on the right side of the display
2.align the MSR tabs into the holes and slide down so that the MSR is flush against the display
3.route theMSR cable in the groove and attach it to the back side of the display
4.at the back of the MSR device, tighten the thumbscrew to secure it to the display
B) 1. with a screwdriver, pop out the MSR hole plugs on the left side of the display
2.align theMSR tabs into the holes and slide down so that the MSR is flush against the display
3.route the MSR cable in the groove and attach it to the port on the rear connector panel
4.at the back of the MSR device, tighten the thumbscrew to secure it to the display
C) 1. with a screwdriver, pop out the MSR hole plugs on the right side of the display
2.align the MSR tabs into the holes and slide down so that the MSR is flush against the display
3.remove the tower center cover to access the MSR connector 4.route the MSR cable in the groove on the back of the display and attach it to the connector in the center of the system
D) 1. open the bezel and remove the MSR plugs
2.with the bezel open, position the MSR tabs in the holes
3.connect the MSR cable to the connector on the operator card
4.close and secure the bezel

質問と回答：