最新のGB0-341-ENU問題集で試験を準備する

H3C GB0-341-ENU 試験概要:

H3C GB0-341-ENU 試験シラバストピック:

H3CSE-WLAN 認定 GB0-341-ENU 試験問題：

1. The physical layer transmission bandwidth of the current mainstream i WiFi protocol g 802.11g is 54 Mbps, but the actual available bandwidth above the transmission layer is about?

A) 40M
B) 24M
C) 32M
D) 16M

2. Which of the following statements about the use of the g debugging command is correct? (Multiple choice)

A) Use certain debugging commands only when looking for certain types of traffic or faults and the cause of the fault has been narrowed down to a possible range. This can reduce the impact of debugging commands on device performance on the one hand, and on the other hand Reduce the output of a lot of useless information, which is conducive to more rapid fault location
B) Try to use it during the low peak period of network usage or when there are few network users to reduce the impact of debugging commands on the system
C) The debugging command should be used to find faults, not to monitor normal network operation
D) Do not use the debugging command lightly without fully grasping the working process of the debugging command and the information it provides
E) Because the debugging commands occupy different system resources in each output direction, depending on the network load, we should choose between ease of use (info-center console debugging command) and low resource consumption (info-center logbuffer debugging command) Out of balance

3. Enable the user based on the number of load balancing between AP1 and AP2, specific parameters are: the session = 5, GAP = 2. Suppose AP1 is connected to 6 clients, and AP2 is connected to 4 clients. At this time, AP1_____ rejects new client access, AP2______ rejects new client access; when AP1 is connected to 6 clients, and AP2 is connected to 5 clients, at this time AP1_____ rejects new client access, AP2______ rejects new client access;

A) will; will not; will not; will not
B) will not; will not; will not; will not
C) will; will not; will; will not
D) will not; will not; will; will not

4. Which of the following descriptions about H3C FIT AP registration is correct? (Multiple choice)

A) There should be a FITAP software matching its version in the AC's flash, and make sure that the name is correct.
B) During the registration process, the FIT AP displays ImageLoad, indicating that the FIT AP is downloading software from the AC.
C) During the FIT AP registration process, you must ensure that the model added on the AC is consistent with the actual device.
D) After the FIT AP is successfully registered on the AC, the displayed status is Run: If the registration is unsuccessful, the displayed status is Idle.

5. Which of the following operations can be the easiest and most effective way to avoid interference in the AP working environment?

A) Adjust AP working channel
B) Adjust the VLAN attributes of the SSID
C) Restart the AP device
D) Replace the AP antenna

質問と回答：