Citrix NetScaler 10 Essentials and Networking 認定 1Y0-350 試験問題:

1. Scenario: A NetScaler engineer needs to enable access to some web servers running on an IPv6only network. The clients connecting the services are on an IPv4 network. The engineer has already enabled IPv6 on the NetScaler.
What does the engineer need to do in order to provide access to the services on the IPv6 network?

A) Create a IPv4 virtual server and bind the service group to it.
B) Create an IPv6 ACL and a IPv4 virtual server and bind the ACL to the virtual server.
C) Configure an IPv6 VLAN and bind the required interface.
D) Create an IPv6 tunnel and a IPv4 virtual server.

2. The network engineer is investigating issues and suspects that one of the administrators recently changed the NetScaler configuration.
Which command could the engineer run to check the logs that will contain such details?

A) nsconmsg -K newnslog -d stats
B) nsconmsg -K newnslog -d stats -d current
C) nsconmsg -K /var/nslog/newnslog -d event
D) nsconmsg -K /var/nslog/newnslog -d consmsg

3. Scenario: A network engineer has bound a service group containing four web servers to a virtual server. The virtual server is UP but users report that they are unable to access the virtual server.
In order to troubleshoot this issue, the engineer should use telnet from __________. (Choose the correct option to complete the sentence.)

A) a PC to the subnet IP address
B) a PC to the mapped IP address
C) a PC to the virtual IP address
D) the NetScaler shell to one of the web servers

4. Scenario: The network engineer has created a monitor and bound it to a service group containing four web servers to verify that the web application responds. During routine maintenance one of the web servers is shut down; however, the server state remains UP and user requests are still attempting to communicate with the server.
What could be causing this problem?

A) Health monitoring is disabled for the service group.
B) The NetScaler configuration has not been saved since before the monitor was bound.
C) The server has been disabled.
D) The monitor is not bound at the correct bind point.

5. NSROOT is the only account configured with super user rights.
In order to initiate the password recovery procedure, the engineer must __________. (Choose the correct option to complete the sentence.)

A) logon using SCP and modify ns.conf
B) connect to the physical NetScaler device
C) logon using nsrecover/nsroot and reallocate licenses
D) connect using SSH to the NetScaler device

質問と回答：